Brodit 736329 holder Tablet/UMPC Black

The holder is also perfect for use in stores, at exhibitions and any place where you want to use your Tab Active 4 Pro without having it easy removable. The holder is equipped with a lock. In order to remove the Tab Active 4 Pro from the holder you need the key, two keys are included. The holder is equipped with a USB-Host port so you can connect an accessory. The active holder is to be connected inside the dashboard. It provides a discreet and neat installation without any cables hanging over the interior. Safe and convenient! 12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2,7 A charger. Charging via pogo plug. Professional installation recommended. Easy-switching system: The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds. This is a Module Upgrade Cradle, this means that you can upgrade or replace features by using some of the following modules: Item no. 216329 Spring stud lock Choose installation placement with care, devices must not be placed in positions where they may block the view or important controls. The cradle should only be attached onto a suitable place. Installations always take place at the customer's own discretion and responsibility.